"Press out" Quotes from Famous Books
 ... relief to have picked up this depot and, for the time, anxieties are thrust aside. There is no doubt we have been rising steadily since leaving the Shambles Camp. The coastal Barrier descends except where glaciers press out. Undulation still but flattening out. Surface soft on top, curiously hard below. Great difference now between night and day temperatures. Quite warm as I write in tent. We are on tracks with half-march cairn ahead; have ...
— Scott's Last Expedition Volume I • Captain R. F. Scott
... off stalks of 3 quarts fresh spinach, discarding stale leaves if any. Thoroughly wash and drain, plunge in gallon boiling water with 1 tablespoon salt and boil for 10 minutes. Take them up with skimmer, drain on sieve, press out all water, chop finely, place in saucepan. Cut 3 slices bread in 1/3 inch square pieces, place on plate, pour over them 1 tablespoon vinegar, then brown them in small frying pan with 1 tablespoon melted Crisco to golden color, add them to spinach, with 2 hard-cooked eggs cut ...
— The Story of Crisco • Marion Harris Neil
... naked," went on Cissie in the monotone that succeeds a fit of weeping, "and ashamed—and afraid." She blinked her eyes to press out the undue moisture, and looked at Peter as if asking what else she could do about it than to go ...
— Birthright - A Novel • T.S. Stribling
... slices of carrot, salt, pepper, half a small cupful of barley. Put on the bones of the poultry and meat with the water. Have the vegetables cut very fine, and cook gently twenty minutes in the butter; then skim them into the soup pot, being careful to press out all the butter. Into the butter remaining in the pan put the flour, and when that is brown, add the curry powder, and stir all into the soup. Cook gently four hours; then season with salt and pepper, and strain. Return to the pot and add bits ...
— Miss Parloa's New Cook Book • Maria Parloa
... as shown. H is fastened into the slot of S B. To do this the end of H is hammered flat until it will just slip into the slot. It may be soldered there, or be made to fit by expanding it so that it will press out against the sides of the slot. To do this, place S B into a hole in an anvil, or hold it in a vise, being careful not to injure the thread. Place the flattened end of H in the slot, and strike it on top so that it will expand and be pinched in the slot; but do ...
— How Two Boys Made Their Own Electrical Apparatus • Thomas M. (Thomas Matthew) St. John |
