"Shellac" Quotes from Famous Books
 ... that the head of the primer shall be placed flat and pressed close upon the vent, that the hammer may strike it fairly. The tip of shellac, by which the lower end of the tube is sealed, occasionally obstructs the jet of flame so as to split the tube. In this case the flame is dispersed laterally, and fails to ignite the charge; it is therefore a good precaution to pinch the end ...
— Ordnance Instructions for the United States Navy. - 1866. Fourth edition. • Bureau of Ordnance, USN
... wish, by mixing the three materials in different proportions. For making gold lacker, put into a clean 4 gallon tin 1 lb. ground turmeric, 1-1/2 oz. powdered gamboge, 3-1/2 lbs. powdered gum sandrack, 3/4 lb. shellac, and 2 galls. spirits of wine; after being dissolved and strained add 1 pint of turpentine varnish, receipt No. 112, well mixed, and it is ...
— Young's Demonstrative Translation of Scientific Secrets • Daniel Young
... to be used to form a complete metallic circuit, for at that time it was not known, as was shortly afterward discovered, that the earth could be used to form one-half of the circuit. For purposes of insulation the wires were neatly covered with cotton-yarn and then saturated in a bath of hot gum-shellac, but this treatment proved defective in insulating properties, for when ten miles of line had been completed the wires were found to be ...
— The Great Events by Famous Historians, Vol. 17 • Charles Francis Horne
... the entrance of bacteria and mold. Among the methods that have met with the most success are burying eggs in oats, bran, or salt; rubbing them with fat; dipping them in melted paraffin; covering them with varnish or shellac; and putting them down in lime water or in a ...
— Woman's Institute Library of Cookery, Vol. 2 - Volume 2: Milk, Butter and Cheese; Eggs; Vegetables • Woman's Institute of Domestic Arts and Sciences
... issued in 1866, are usually said to be on gold-beater's skin. But they are really on a very thin tough paper which has been treated with shellac, parrafine, or something which makes it transparent, and afterwards coated with a gelatine preparation. On this the design was printed reversed, i.e. only to be seen correctly when viewed through the paper. The stamps ...
— What Philately Teaches • John N. Luff |
